News

Posted at 2025-09-024 Views

1. Grinding Wheel Linear SpeedIncreasing the grinding wheel linear speed reduces the maximum depth of cut of the abrasive grains, reducing the chip cross-sectional area.It also increases the number of cuts and grinding h···

Read more
Posted at 2025-08-2625 Views

The basic principle of hot pressing is to press the part using heat.This causes the binder to melt rapidly, then condense and harden or semi-harden during the dwell time.Hot pressing simultaneously compresses and hardens···

Read more
Posted at 2025-08-1841 Views

In recent years, micro-sized V-shaped grooves have been designed on substrates used in fiber optic docking,medical cell analysis, and photovoltaic cell lamps.These grooves enable new functions such as positioning fine fi···

Read more
Posted at 2025-08-1150 Views

The grinding performance of a grinding wheel depends not only on its structural characteristics, such as abrasive grain size,hardness, and so on, but also on its surface topography. This refers to the instantaneous state···

Read more
Posted at 2025-08-0661 Views

1. Burns: Caused by excessive feed rate, insufficient coolant, too fine abrasive grit, too hard a bond, and high temperatures in the grinding zone.2. Clogging and blunting: Caused by improper abrasive selection, improper···

Read more